Please choose your delivery location

The selection of the country/region page can influence various factors such as price, shipping options and product availability.
My contact person
OEM Finland OY

Fiskarsinkatu 3

20750 Turku

+358 207499499
+358 207499456
FI(EN)

Assembling single rail with a carriage

Parts list - Microflizz® & required tools

Parts list (with one channel element)
  • Aluminum profile
  • 2 Cover plates
  • 8 Torx screws
  • 4 Cross-head screws
  • 2 Metal pins
  • Preassembled chain with carriage
Tools required for assembly
  • Cross-head screwdriver
  • Torx screwdriver, size 20
  • Plastic and metal hammers
  • Allen key, size 4
1) Fasten "closed" cover plate (A) on outer end of the guide channel (B) with four Torx screws (C)
2) Insert e-chain® with carriage (D) in channel so that the "wings" of the energy chain are guided in the channel
3) Fasten connecting element (E) from above with two cross-head screws
4) Fit "open" cover panel (F) to the other end of the guide channel and fasten with four Torx screws (C)
1) Hammer metal pin (G) into required side of channel with metal hammer
2) Attach connection plate (H) on the same side, push it as far as the middle and fasten with M6 set screw
3) Put feed module (J) in place and fit together with plastic hammer
5) Fit together other channel element(s) (see steps II,1 and II,2) and tighten 2nd screw on connection plate (H)
6) Insert first e-chain® with carriage (D) with the connection element (E) forwards into channel. Please note correct installation direction of the carriage!
7) Insert second energy chain into channel (like II,6)
8) Connect e-chains® with channel element. Align so that the teeth on the strain relief (L) are flush with the inside edge of the channel
9) Connect e-chain® at sides through the channel with four cross-head screws (two each side)
10) Assemble cover plates on both sides ("closed" version)
10) Completely assembled Micro flizz® with several channels and two carriage
Simple assembly of Micro flizz®
Assembly of 2 micro flizz® systems


The terms "igus", "Apiro", "chainflex", "CFRIP", "conprotect", "CTD", "drylin", "dry-tech", "dryspin", "easy chain", "e-chain", "e-chain systems", "e-ketten", "e-kettensysteme", "e-skin", "e-spool", "flizz", "ibow", "igear", "iglidur", "igubal", "igutex", "kineKIT", "manus", "motion plastics", "pikchain", "readychain", "readycable", "ReBeL", "speedigus", "triflex", "robolink", "xirodur", and "xiros" are legally protected trademarks of the igus® GmbH/ Cologne in the Federal Republic of Germany and where applicable in some foreign countries.

igus® GmbH points out that it does not sell any products of the companies Allen Bradley, B&R, Baumüller, Beckhoff, Lahr, Control Techniques, Danaher Motion, ELAU, FAGOR, FANUC, Festo, Heidenhain, Jetter, Lenze, LinMot, LTi DRiVES, Mitsubishi, NUM,Parker, Bosch Rexroth, SEW, Siemens, Stöber and all other drive manufacturers mention on this website. The products offered by igus® are those of igus® GmbH